HMI Displays

AirHMI Mobile CANBus / J1939 Vehicle Displays

An AirHMI Industry display and a CANBus – UART board in one housing. Power, ignition and the CAN bus connect through the 5-pin connector at the back; vehicle data is read from the J1939 bus and shown on gauges you design yourself.

3 models

AirHMI Mobile CANBus / J1939 Vehicle Displays
Size

Showing 3 products

Model Comparison

All three models have a built-in CANBus – UART board, SAE J1939, 9–36 VDC supply, an ignition input and a 5-pin connector.

AirHMI Mobile 5"AirHMI Mobile 7"AirHMI Mobile 10.1"
Resolution800 × 480800 × 4801024 × 600
TouchResistiveCapacitiveCapacitive
Display packageIndustryIndustryIndustry
CANBus / SAE J1939
Ignition input (KL15)
Power supply9–36 VDC9–36 VDC9–36 VDC
Connector5 pins5 pins5 pins

Applications and Compatibility

Where is it used?

  • Cab display in construction and agricultural machines
  • Control display for bodies such as refuse trucks, sewer trucks and fire engines
  • Additional instrument and fault code display in buses and trucks
  • PLC-free vehicle control system together with SmartIO CANLink

Frequently asked questions

Which vehicle data can it show?

Messages broadcast on the J1939 bus are read: engine speed, vehicle speed, coolant temperature, fuel level, oil pressure, battery voltage and DM1 fault codes, for example. The board filters messages by ID and the project on the display decodes and shows them.

What is the ignition input for?

It senses the vehicle ignition (KL15): the display wakes when the ignition is on and sleeps after a set time when it is off, so it does not drain the battery while the vehicle is parked.

What supply voltage does it need?

9–36 VDC; it runs directly in 12 V and 24 V vehicles.

What is on the connector?

5 pins: 1 +24 V (9–36 VDC), 2 GND, 3 ignition (KL15), 4 CAN H, 5 CAN L.

Who designs the interface?

The interface is designed with the free AIRHMI Designer; if you prefer, our engineering team prepares the project for you.

How is it sold?

It is priced by project and quantity; request a quote. In volume projects the interface and housing are adapted to your company.

Compatible products

About the Series

AirHMI Mobile are CANBus HMI displays for construction and agricultural machines, truck and bus bodies and special-purpose vehicles. The AirHMI Industry display and the CANBus – UART board sit in the same housing; only a 5-pin vehicle connector comes out of the back: +24 V, GND, ignition, CAN H and CAN L.

The board filters 29-bit J1939 messages by ID; the project on the display shows data such as engine speed, vehicle speed, temperature, fuel and fault codes. Body equipment is controlled on the same bus with SmartIO CANLink modules.

With a 9–36 VDC supply it runs in 12 V and 24 V vehicles; the display wakes when the ignition is switched on and goes to sleep after a delay when it is switched off. For volume projects, the interface and housing are adapted to your company.

CANBus and SAE J1939

Built-in board; 29-bit ID filtering

Ignition Sensing

Wakes with the ignition, sleeps after a delay

Single Connector

5 pins: +24 V, GND, ignition, CAN H, CAN L

Let's choose the right model for your project together

Tell us your size, touch and connectivity requirements and our engineering team will recommend the right configuration.